1999 Ford Taurus Camshaft Position (CMP) Sensor SHO Removal Installation
download Camshaft Position (CMP) Sensor SHO Removal 1. Disconnect battery ground cable (14301) . Refer to Section 14-01. 2. Remove the engine appearance cover. For additional information, refer to...
View Article2003 Nissan Pathfinder SE Fan Control Amplifier
download Fan Control Amplifier The fan control amplifier is located on the cooling unit. The fan control amp. receives a gate voltage from the auto amp. to step-lessly maintain the blower fan motor...
View Article2002 Jeep Wrangler CMP and CKP Removal and Installation
download The Camshaft Position Sensor (CMP) on the 4.0L 6cylinder engine is bolted to the top of the oil pump drive shaft assembly. The sensor and drive shaft assembly is located on the right side of...
View Article2006 Chevy Avalanche 1500 Fan Clutch Replacement
download Removal Procedure 1. Remove the upper fan shroud. 2. Install the J 46406 and the J 41240-5A to the fan clutch. 3. Remove the fan hub nut from the water pump in a counterclockwise rotation. 4....
View Article2004 Chevy Silverado 3500 Fan Clutch: Service and Repair Fan Clutch Replacement
download Removal Procedure 1. Remove the upper fan shroud. 2. Install the J 46406 to the fan clutch. 3. Remove the fan hub nut from the water pump in a counterclockwise rotation. 4. Remove the fan...
View Article2003-2006 Chevrolet Express Antilock Brake (ABS) Activation At Low Speeds...
download Condition Some customers may comment on ABS activation at low speeds, usually below 8 km/h (5 mph). Upon investigation, the technician will find no DTCs set. Cause The cause of this condition...
View Article2002 Ford F 150 Cooling Fan – Blade, Clutch and Shroud Removal and Installation
download WARNING: Do not run the engine while the protective components are removed. Failure to follow these instructions may result in personal injury. All vehicles 1. Remove the air cleaner assembly....
View Article2003 Chevy TrailBlazer Radiator Cooling Fan: Description and Operation
download Cooling Fan Control The purpose of the Electro-Viscous (EV) fan clutch is to maintain powertrain cooling requirements. The Powertrain Control Module (PCM) monitors the following sensors to...
View Article1998 Ford Windstar Camshaft Position (CMP) Sensor REMOVAL AND INSTALLATION
download CAUTION: Prior to removal of the camshaft position sensor (CMP sensor) (12126) , set cylinder No.1 to zero degrees top dead center (TDC) of compression stroke. Then note the position of the...
View Article1995 Ford Mustang Camshaft Position (CMP) Sensor Removal Installation
download 1. Disconnect battery ground cable (14301) . 2. Disconnect fuel charging wiring (9D930) from distributor stator (12A112) (camshaft position sensor). 3. Remove stator camshaft position sensor...
View Article
More Pages to Explore .....